5/20/2023 0 Comments Diy magic mirror![]() Once that was complete, the Raspberry Pi computer was added. A sensor in the bottom of the frame allows the mirror to turn on and off with the wave of your hand. The Redditor even added a small Bluetooth speaker. LED lighting was added for an additional illuminated effect. The parts were secured with insulation tape. After the frame was complete, Toothie96 rearranged and desoldered some of the electronics to ensure they'd fit flush with the back of the mirror. This DIY magic mirror displays helpful information on its face. “Honestly, even with the Magic Mirror framework, there's still so much code to get your head around when things don't work out first time, especially for someone with no coding experience.” Redditor Toothie96 created the type of mirror you'd see in a fairy tale. “On a scale of 1-10, I’d give it a 6,” Toothie admits. While daunting, many hours later, he got it working. Toothie96 had never coded before, so he looked to the open source MagicMirror2 framework for guidance. The most time consuming part of the whole endeavor was the coding for the mirror's user interface. Then, a small Raspberry Pi computer was fitted into back this vital piece of technology controls all of the information on the front of the mirror. He also added a Bluetooth speaker and a sensor so that you can swipe your hand over the mirror to turn it on and off. For additional illumination, he wrapped the frame in LED lights. So, how did Toothie96 get the information to show up on the mirror? After all, he wrote, “Normal mirrors don't let light through them.” He obtained a custom-cut piece of two-way glass that allowed some light to shine through. ![]() This required a bit of desoldering parts and rearranging them so they would lie flush with the back housing. “Due to the limited depth of the back housing, everything had to be modified to ensure it would fit,” he said. ![]() After that was perfected, he moved onto the electronics. ![]() Software OnlyĪ software registration key will be e-mailed to you after your Paypal payment has been received.To begin this project, Toothie96 chopped pine wood and secured it into a frame that was deep enough to hold all of the technology. If you already have an Arduino and can build the circuit yourself, you can also purchase just the software. The Magic Mirror kit can be purchased from Seeedstudio. A fully assembled Sensor Hub with case and built in Breathalyzer is also available below. If building your own circuit, the software may be purchased stand alone below. Magic Mirror Software Setup Video Tutorial (7:35 min) Purchase the assembled kit directly from Seeedstudio. 10K Potentiometer Lug Pins (to be externally mounted).Magic Mirror Software Registration Code.Assembled Magic Mirror Shield with Seeeduino Atmega328 (pre-loaded with Firmata software).Magic Mirror Kit Assembled, Software, and Seeeduino (Arduino Equivalent) The Magic Mirror Kit does make the job much easier though and is now available assembled from Seeedstudio. The Magic Mirror hardware is open source so you can build the hardware yourself and just buy the software. **** This Version of the Kit is No Longer Availabile **** * Some soldering is required for the Maxbotix LV EZ-1 Proximity Sensor as in this diagram, solder points close-up Now with Support for Plug and Play Sensors (No Soldering!) Sensors Purchased Separately from Seeedstudio
0 Comments
Leave a Reply. |